tag:blogger.com,1999:blog-1556931622438985208.post8391760879710319664..comments2022-10-13T08:19:38.170-07:00Comments on The Synth and I: Meet Mr. Modular Preset...Legionhttp://www.blogger.com/profile/12932507206327457165noreply@blogger.comBlogger2125tag:blogger.com,1999:blog-1556931622438985208.post-13087326839667768542011-05-30T17:23:23.810-07:002011-05-30T17:23:23.810-07:00The 250e can be clocked externally. Light the Edit...The 250e can be clocked externally. Light the Edit LED. press the MODE button (the gray one) until the mode LEDs are off and hold it there. Now twist the center knob to apply the change to all the stages. Now a pulse in the Mode jack will advance the sequencer. <br /><br />Alternatively, you can put the 250e in continuous mode (lower right) and feed it a CV to make it go around. Once you have this mastered, put it in strobe mode and apply a pulse to the strobe input. At this point you have a quantized sample and hold.<br /><br />Dougdougclhttps://www.blogger.com/profile/07848326229558247592noreply@blogger.comtag:blogger.com,1999:blog-1556931622438985208.post-71489229951418085172011-05-30T17:19:50.791-07:002011-05-30T17:19:50.791-07:00With the 259e, you must cross the preset value by ...With the 259e, you must cross the preset value by turning the knobs before the knobs have any effect. After loading a preset, it's common to ramp the knobs back and forth to get control back.dougclhttps://www.blogger.com/profile/07848326229558247592noreply@blogger.com